Radiographic Testing is a non-destructive testing (NDT) method which uses either x-rays or gamma rays to examine the internal structure of manufactured components identifying any flaws or defects.

Chemical, Mechanical, Corrosion Testing including Hydrogen Induced Cracking (HIC) & Sulfide Stress Corrosion Cracking (SSC).– These tests are conducted to find out the chemical analysis as well as the physical properties such as Tensile, Elongation, Hardness, Impact, etc.

Ultrasonic testing (UT) is a type of non-destructive testing techniques based on the propagation of ultrasonic waves in the object or material tested. In most common UT applications, very short ultrasonic pulse-waves with center frequencies ranging from 0.1-15 MHz, and occasionally up to 50 MHz, are transmitted into materials to detect internal flawssuch as laps, laminations, blowholes, cracks etc. or to characterize materials. A common example is ultrasonic thickness measurement, which tests the thickness of the test object, it is also used to monitor pipework corrosion& weld joints.

Magnetic particle Inspection (MPI) is a non-destructive testing (NDT) process for detecting surface and slightly subsurface discontinuities in ferromagnetic materials such as iron, nickel, cobalt, and some of their alloys. The process puts a magnetic field into the part.

This is a non-destructive method to find out the hardness of any material

This performed to verify the chemical constituents of the pipes and check the % of alloying elements such as Chrome, Molybdenum, Nickel, Manganese, etc. without destroying the product so as to not mix up different grades of materials such as P11, P22, P5, P9, P91, SS – 304, 310, 316L, 321, etc.

Dye Penetrant Inspection (DP)is a widely applied and low-cost inspection method used to locate surface-breaking defects in all non-porous materials (metals, plastics, or ceramics).The penetrant may be applied to all non-ferrous materials and ferrous materials, although for ferrous components magnetic-particle inspection is often used instead for its subsurface detection capability. LPI is used to detect casting, forging and welding surface defects such as hairline cracks, surface porosity, leaks in new products, and fatigue cracks on in-service components.

The vernier, dial, and digital calipers give a direct reading of the distance measured with high accuracy and precision generally used for measuring Outside Diameter, Thickness &Inside Diameter of pipe / Tube.

Threading Gauge is used to measure the pitch or lead of a thread.

To check the thickness of the galvanizing coating applied on a pipe.